RFXCOM RFXtrx433XL - Protocol Sensitivity Influence; Sensitivity influenced by enabled protocols

Copyright 2011-2020, RFXCOM RFXtrx Version 5.68 page 20 / 70
2.4. Sensitivity influenced by enabled protocols
All protocols can be enabled in the Pro firmware versions; however it is still preferred to enable
only the protocols used for receive.
The sensitivity of the receiver part is highly influenced by the number of protocols enabled in
Type1, Type2, Ext or Ext2 firmware. Lesser protocols enabled will make the receiver more
sensitive for the enabled protocols.
There are a few protocols that will reduce or even eliminate receiving of other protocols if
enabled in Type1, Type2, Ext or Ext2 firmware.
For example:
If the AD (LightwaveRF, Siemens) protocol is enabled it can stop receiving of Meiantech /
Atlantic, Oregon 3.0,Visonic and Mertik.
All other protocols are disabled if BlindsT0 is enabled in Type1, Type2, Ext or Ext2 firmware.
X10
ARC
AC
HomeEasy EU
Meiantech/Atlantic
Oregon 1.0
Oregon 2.1
Oregon 3.0 / OWL
ATI
Visonic/Keeloq
Mertik
AD (LWRF)
Hideki/UPM
La Crosse
FS20
ProGuard
BlindsT0
BlindsT1/T2/T3/T4
AE (Blyss)
Rubicson/Alecto
FineOffset/Viking
Lighting4
RSL/Revolt
Byron SX
Imagintronix/Opus
HomeConfort
X10
ARC
AC
HomeEasy EU
Meiantech/Atlantic
Oregon
ATI
Visonic/Keeloq
Mertik
AD (LWRF)
Hideki/UPM
La Cross
e
FS20
ProGuard
BlindsT0
BlindsT1/T2/T3
AE (Blyss)
Rubicson
FineOffset/Viking
Lighting4
RSL
Byron SX
Imagintronix
HomeConfort
Green = enabled by default