HEAT PUMP AND TANK ASSEMBLY
12
2. Heat Pump Module: Place the heat pump module in front of the storage
tank and open the top flaps of the carton.
Two (2) lifting bars are housed in a recess in the cardboard layer on top of
the heat pump module.
Remove the lifting bars and set them aside.
Remove the carton from the heat pump module.
Be aware the carton sides have flaps, which tuck under the carton
base of the heat pump module.
3. Air Louvre Removal: Using a Phillips head screw driver, remove the
six (6) screws from each of the two air louvres (twelve (12) screws in total).
Remove the louvres from the heat pump module.
4. Electrical Cover: Remove the mounting screw from the side of the
electrical cover.
Gently remove the cover.
The electrical cover needs to be handled gently so as not to damage
the electronic controls located behind the electrical cover.
Step 4
remove electrical cover
To Next Page
Loading...
