Rheem Classic Series User Manual

8
Installing the water heater.
Combustion and Ventilation Air
Proper operation of the water heater
requires air for combustion and
ventilation. Provisions for combustion
and ventilation air must comply with
referenced codes and standards.
NOTICE: If the water heater is
installed in an unconfined space within a
building of conventional frame, masonry
or metal construction, infiltration
air is normally adequate for proper
combustion and ventilation. If the water
heater is installed in a confined space,
provisions for ventilation air must be
made.
All air for combustion and all products of
combustion are routed through the ducting
provided, directly from and to the outside
of the building.
NOTICE: If the duct openings which
supply ventilation air are to be covered
with a protective screen or grill, the net
free area (openings in the material) of
the covering material must be used in
determining the size of the openings.
Protective screening for the openings
MUST NOT be smaller than 1/4”mesh
to prevent clogging by lint or other
debris.
Corrosive Atmospheres
The air in beauty shops, dry cleaning
establishments, photo processing
labs, and storage areas for liquid and
powdered bleaches or swimming pool
chemicals often contain such halogenated
hydrocarbons.
An air supply containing halogenated
hydrocarbons may be safe to breathe,
but when it passes through a gas flame
corrosive elements are released that
will shorten the life of any gas burning
appliance.
Propellants from common spray cans
or gas leaks from A/C and refrigeration
equipment are highly corrosive after
passing through a flame.
The water heater warranty is voided when
failure of the heater is due to operation in
a corrosive atmosphere.
NOTICE: The water heater
should not be installed near
an air supply containing
halogenated hydrocarbons.
Inspect Shipment
Inspect the water heater and the venting provided with the water heater for possible
damage. Check the markings on the rating plate of the water heater to be certain the
type of gas supplied corresponds to the water heater requirements.

Rheem Classic Series Specifications

General

Brand	Rheem
Series	Classic Series
Dimensions	Varies by model
Weight	Varies by model
Category	Residential
Fuel Type	Electric, Natural Gas, Propane
First Hour Rating	Varies by model
Energy Factor	Varies by model
Recovery Rate	Varies by model
Capacity	40-80 gallons
Tank Capacity	40-80 gallons