INSTALLATION CHECK LIST
REFER TO INSTALLATION INSTRUCTIONS
++-(($1
Adequate pipe size
C
orrect supply pressure (during furnace operation)
Manifold pressure
No gas leaks
L.P. Kit Number (if applicable)
$,*!$
115 V.A.C. supply (Single Circuit)
Polarity observed
Furnace properly grounded
Adequate wire size
-*&!&+,$$,!'&
Adequate clearance to combustibles
Adequate clearance for service (at front)
in. w.c. on heating speed
in. w.c. on cooling speed
Air temperature rise
'&&+,$!&
Trap filled with water
Vented
Sloped toward drain
Condensate drain line hoses connected
and clamped
Freeze protection (if necessary)
.&,!&O!*,.&,
in. diameter – intake pipe
in. diameter – exhaust pipe
ft. of pipe – intake air
no. of elbows – intake air
ft. of pipe – exhaust pipe
no. of elbows – exhaust pipe
Exhaust vent temp.
,*%!&,!'&+O!*,.&,
V
ERTICAL
Intake – 12" min. above roof/snow level
Correct relationship – exhaust to intake
HORIZONTAL/VERTICAL – CONCENTRIC (RXGY-E03A)
Intake – 12" min. above roof/snow level
Intake “Y” rotated above center
Exhaust sloped toward furnace
HORIZONTAL – STANDARD (RXGY-D02, -D02A, -D03,
D03A)
Correct relationship – exhaust to intake
12" min. above grade/snow level
HORIZONTAL – ALTERNATE (RXGY-D02, -D02A, -D03, -
D03A)
Correct relationship – exhaust to intake
Above anticipated snow level
.&,!&O&'&!*,.&,
in. diameter – exhaust pipe
ft. of pipe – exhaust
no. of elbows
,*%!&,!'&O&'&!*,.&,
VERTICAL
12" min. above roof/snow level
HORIZONTAL – STANDARD
12" min. above grade/snow level
HORIZONTAL – ALTERNATE
Above anticipated snow level
Model Number
Serial #
Date of Installation
2