Rheem GF951U Series - Page 50

!-*
-,>75FDA@;5A@FDA>E
$'/*',!%!&+
!
/*&!&
SETTING BLOWER
TIMINGS
The Honeywell UT ELECTRONIC
C
ONTROLS and Invensys Climate
Controls IFC’S (Integrated Furnace
Controls) have three or four quick
connect terminals for connecting the
motor speed leads. These are:
1. FAN SPEED — motor runs on
this speed when the thermostat
i
s in the “FAN ON” position.
2. COOL — connect desired
cooling speed.
3. HEAT — connect desired
heating speed.
4. HEAT/COOL (not available on
UT Electronic Controls-1028-925
control board) or Invensys
Climate Controls ICC-H1MC7-01
— connect desired speed when
heating and cooling speed are
the same.
!%('*,&,Do not connect any
motor speeds to “HEAT” and “COOL”
if you use the “HEAT/COOL” terminal.
5. If heating and continuous fan
speed are the same, “piggyback”
jumper across “FAN” and “HEAT”
terminals.
See Figures 51, 52 & 53 for
instructions for setting the blower
“OFF” timings.
If cooling speed and fan speed are
desired to be the same, this may be
accomplished by not connecting “Y”
to the integrated furnace control.
If desired for cool, fan and heat to all
be the same speed, then “piggyback”
jumper “H/C” to “FAN” and do not
connect “Y” to the integrated furnace
control. Do not connect anything to
“H” or “C.”
GAS FURNACE (DIRECT
DRIVE) INSTRUCTIONS
FOR CHANGING BLOWER
SPEED
!+'&&,, $,*!$
+
-(($1,', -*&
'*,,%(,!&,'
 &, $'/*+(
!$-*,''+'&-+
$,*!$+ '#*+-$,!&
!&(*+'&$!&"-*1'*, 
The blower motor is wired for blower
speeds required for normal operation
as shown.
If additional blower speed taps are
available (leads connected to “M1”
and “M2” on the electronic control),
speeds may be changed if necessary
to fit requirements of the particular
installation. Reconnect the unused
motor leads to “M1” or “M2.” Check
motor lead color for speed
designation.
Heating speeds should not be
reduced where it could cause the
furnace air temperature to rise to
exceed the maximum outlet air
temperature specified for the unit.
!%('*,&,Always check air
temperature rise after changing the
heating speed for any reason.
!-*
-,>75FDA@;5A@FDA>E
!@H7@EKE>;?3F7A@FDA>E
! %
$'/*',!%!&+
OFF TIME SWITCH 1 SWITCH 2
90 SEC. OFF ON
120 SEC. OFF OFF
160 SEC. ON OFF
180 SEC. ON ON
,!%*!+
*
$'#
'&'*
I335

!-*
-,>75FDA@;5A@FDA>E
$'/*',!%!&+
OFF TIME SWITCH 1 SWITCH 2
90 SEC. OFF ON
120 SEC. OFF OFF
1
60 SEC. ON OFF
1
80 SEC. ON ON
,/!&
+!&$
&',+/!, !+-+'*
,
/!&&!&(($!,!'&+
'
&
I
402
50