Rheem GHE100SU - User Interface; Alarm Management and History; Troubleshooting Information Access; System Health Monitoring

17
Installation
Figure - 11- Typical Horizontal Power Vent System
* A 6 inch pipe can be used on 300,000 Btu/h models and above.
EVERY 3' MAX.
When 6 inch pipe is used, start pipe
supports as close as possible to unit.
2, 3, 4, OR 6*
INCH PIPE AND
FITTINGS
SUPPORT BRACKET
45° TERMINAL
1 IN. MAX.
WALL
WATER
HEATER
NOTE: Horizontal
venting shall be
installed with a slight
upward slope of 1/4"
per foot.
DRAIN
PAN
FLOOR