EasyManuals Logo

Rheem HB Series User Manual

Rheem HB Series
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
21
Cavity Insert Instructions
The following instructions are intended for qualified
service personnel ONLY, and should only be done
when necessary.
In order to replace the ECO,thermistor or heating
element, remove the cavity insert crossbar by
following the instructions below:
Turn off the power to the water heater.
Remove the jacket access panel(s) and insulation.
Rotate the crossbar up and down until it breaks
away from the remainder of the cavity insert.
(See illustration to the left)
Discard the crossbar. It cannot and need not be
replaced.
Replace the ECO,thermistor and/or element
as necessary.
Replace the insulation, jacket access panel(s) and
plastic housing before turning on the power to
the water heater.
NOTICE: The cavity insert crossbar is necessary
for the manufacturing process only. The removal
of the crossbar will not interfere with the operation
of the water heater.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rheem HB Series and is the answer not in the manual?

Rheem HB Series Specifications

General IconGeneral
BrandRheem
ModelHB Series
CategoryWater Heater
LanguageEnglish

Related product manuals