To Next PageTo Next Page
Need help?Do you have a question about the Rheem RH1P3017STANAA and is the answer not in the manual?
General| Brand | Rheem |
|---|---|
| Model | RH1P3017STANAA |
| Category | Air Handlers |
| Cooling Capacity | 2.5 Tons |
| Refrigerant | R-410A |
| Phase | 1 |
| Weight | 120 lbs |
Covers power, blower removal, injury, grounding, circuit breakers, and qualified personnel.
Addresses duct leaks, pollutants, CO, combustible bases, and ductwork connections.
Warnings on filters, ductwork, discharge configuration, overflow pans, and Proposition 65.
Tools, specifications, and key handling guidelines for R-410A refrigerant systems.
Procedures for leak testing, evacuation, and refrigerant charging of the system.
Importance of permanent grounding for electrical safety and compliance with codes.
Electrical data for (-)H1P models with various electric heater kits, including kW, amps, and breaker sizes.
Further electrical data for (-)H1P models with electric heater kits, covering different configurations.
Electrical data for (-)H1T models with various electric heater kits, including kW, amps, and breaker sizes.
Further electrical data for (-)H1T models with electric heater kits, covering different configurations.
A checklist of items to verify before starting the system for proper installation and operation.
Procedures for checking system operation after installation, including controls, airflow, and charge.
Describes the sequence of operation for cooling, electric heat, and heat pump heating modes.
Guidance on verifying refrigerant charge after confirming correct indoor airflow.
Information on available electric heater kits, their ratings, and installation instructions.
Lists possible causes and fixes for blower motor problems, vibration, and airflow issues.
Addresses issues like improper heating, frozen coils, water overflow, and TXV control problems.
Schematic and electrical wiring diagram for the (-)H1P model operating on 115V.
Schematic and electrical wiring diagram for the (-)H1P model operating on 208/240V.
Schematic and electrical wiring diagram for the (-)H1P model operating on 480V.
Schematic and electrical wiring diagram for the (-)H1T model operating on 115V.
Schematic and electrical wiring diagram for the (-)H1T model operating on 208/240V.
