To Next PageTo Next Page
Need help?Do you have a question about the Rheem RQPM 15/16 Seer Series and is the answer not in the manual?
Warnings about following instructions and using authorized components.
Mandatory warnings for power disconnection, grounding, and wiring.
Information on fiberglass insulation and Proposition 65.
Specifications, quick reference, coil/TXV, and required tools for R-410A.
Covers pre-installation checks and unit location.
Ensures structural integrity, clearances, power supply, and duct/drain provisions are met.
Details on outdoor installation, slab/rooftop placement, and airflow clearance.
Steps and considerations for installing the unit on an outdoor slab.
Minimum clearances for unit performance and serviceability.
Ensures roof strength, level platform, and proper access for rooftop units.
Guidelines for ductwork fabrication, sizing, and installation.
Details on field-installed filters for return air duct.
Instructions for connecting and maintaining the indoor coil drain.
Describes outdoor coil water runoff during heating and defrost cycles.
Guidelines for branch circuit wiring, disconnects, and wire sizing.
Instructions for connecting power to the unit and electric heater kit.
Guidelines for low voltage wiring and thermostat compatibility.
Instructions for replacing internal wiring with identical components.
Emphasizes permanent grounding for electrical safety.
Guidance on thermostat placement and connection.
Information on multi-speed indoor blower motor performance.
Checks for proper location, level, wiring, grounding, and airflow.
Steps for turning on power and verifying unit operation.
Details compressor behavior, overload protection, and time delay control.
Guidance on auxiliary heat requirements and system control.
Monitors ambient temp, coil temp, and run-time for defrost cycles.
Provides active protection and system lockout based on pressure.
Explains LED status for troubleshooting defrost control issues.
General
