To Next PageTo Next PageWhy is the stubble not the same height with my RHINO AGM72 Lawn Mower?
Uneven stubble height with your RHINO Lawn Mower can be due to several reasons: * The disk carrier bar tilts too much, so reduce the tilt. * The knives are worn, so replace them. * The power takeoff speed is insufficient, so increase the power takeoff rotation speed up to, but not over, 540 revs/min.
How to stop the disk carrier bar from vibrating too much on my RHINO AGM72 Lawn Mower?
Excessive vibration in the disk carrier bar of your RHINO Lawn Mower can be caused by: * Overworn or completely worn-out nylon bushings in the joints. Replace the bushings. * Overworn pins and/or respective bushings/bearings of the joints. Replace the worn-out parts and lubricate regularly. * A slack outer conveyor. Check that it is fastened correctly and check the nylon bushings.
What to do if the safety device on my RHINO Lawn Mower unhooks under impact?
If the safety device on your RHINO Lawn Mower frequently unhooks upon impact, the spring might not be adjusted correctly. Check the condition of the spring and, if necessary, carefully tighten the relevant screw until hooking occurs at reasonable intervals. Be cautious, as over-tightening can cause unhooking with blows that are too strong for the machine structure.
Why doesn't the disk carrier bar adapt to uneven ground on my RHINO AGM72?
If the disk carrier bar on your RHINO Lawn Mower isn't adapting well to uneven ground, it could be due to: * Incorrect height adjustment of the tractor coupling plate. Readjust as specified in the operations section, ensuring both ball-and-socket joints are at the same height above ground. * Machine joints resisting free rotation. Clean and lubricate the parts.
How to fix too high or sparse stubble with my RHINO AGM72?
If the stubble is too high or sparse when using your RHINO Lawn Mower, it may be because the disk carrier bar does not tilt correctly. Use the turnbuckle to adjust the tilt.
What to do if the disk carrier bar is not raised parallel to the ground on my RHINO Lawn Mower?
If the disk carrier bar on your RHINO Lawn Mower isn't raising parallel to the ground, it might be because the entire machine is leaning to one side. Check that both hoist ball-and-socket joints are at the same height above ground; the transverse slant of the chain is not adjusted, correctly adjust the chain to the correct length and fasten one of the circlips into slot.
What to do if earth accumulates in the disk carrier bar of my RHINO AGM72 Lawn Mower?
If earth accumulates between the sliding blocks in the front of your RHINO Lawn Mower's disk carrier bar, it could be due to: * Exceptionally wet ground causing the bar to press too hard. Use the tractor hoist to raise the machine higher above the ground, ensuring minimum height. * The disk carrier bar tilting too far forward. Adjust the tilt of the axle by moving the turnbuckle on the third point.
Why is the forge pushed forward before being cut by my RHINO AGM72?
If the forge is being pushed forward before being cut by your RHINO Lawn Mower, the ventilating effect of the knives might be too strong. Reduce the power takeoff rotation speed and increase the tractor forward movement speed.
General| Brand | RHINO |
|---|---|
| Model | AGM72 |
| Category | Lawn Mower |
| Language | English |
