What causes blade bolts to loosen on a RHINO RB60/72?
If blade bolts are working loose on your RHINO Lawn Mower, it may be because the bolts are not tightened enough; tighten bolts to 300 ft./lbs. If the bolt hole is elongated or oversized, replace the blade carrier. If the locknut is worn out, replace it.
How to fix uneven cut with RHINO RB60/72?
To correct an uneven cut with your RHINO Lawn Mower, consider these factors: Reduce ground speed if it's excessive. If the blades are worn, dull, or bent, replace them. Ensure the mower is level from side to side by making necessary adjustments. Check and adjust the mower height if it's improperly set. Correct low tractor tire pressure on one side and reduce ground speed when turning. Adjust your tractor wheel spacing if the tires are pushing the grass down. Finally, inspect the mower pan for damage and repair or replace it as needed.
What to do if the shear pin keeps shearing on my RHINO RB60/72?
If the shear pin on your RHINO Lawn Mower keeps shearing, ensure the tractor PTO is running at 540 RPM. Reduce ground speed if you're cutting heavy material. Replace the shear pin only with the recommended one. Engage the PTO at idle engine RPM. Increase cutting height in rocky conditions. Check gearbox ratios if the blade carrier RPM is too high. If blades are not properly heat treated, consult your dealer.
Why is my RHINO Lawn Mower gearbox overheating?
If your RHINO Lawn Mower gearbox is overheating, check if the lubricant level is low and fill to the level plug. If you are using an improper type of lubricant, replace it with the proper one. Also, remove any excessive trash build-up around the gearbox. If the bearing or gears are set up improperly, consult your dealer.
What to do if my RHINO Lawn Mower is leaving uncut material?
If your RHINO Lawn Mower is leaving uncut material, reduce ground speed if it's excessive. Ensure you are using full PTO speed. Install blades so the rotation is correct.
How to fix a leaking gearbox on RHINO RB60/72 Lawn Mower?
To fix a leaking gearbox on your RHINO Lawn Mower, start by checking for a damaged oil seal and replace it if necessary. If the shaft is bent, replace both the oil seal and the shaft. Address a rough oil seal race by replacing the shaft or repairing the race. Ensure the oil seal is installed correctly, and if it's not sealing in the housing, replace the seal or use a sealant on the O.D. of the seal. Drain excess oil if the oil level is too high. Replace a damaged gasket. Tighten any loose bolts. For a sand hole in the casting, replace the castings or gearbox.
Why is my RHINO RB60/72 doing a poor job of shredding?
If your RHINO Lawn Mower is not shredding well, it might be due to excessive ground speed. Raise the front of the mower relative to the rear to hold and circulate material longer. Also, lower the cutting height if you are cutting too high.
Why is my RHINO RB60/72 windrowing material unevenly?
If your RHINO Lawn Mower is windrowing material heavily, lushly, or unevenly, reduce ground speed if it is excessive. If conditions are too wet, wait for them to dry.
Why is the gearbox on my RHINO Lawn Mower noisy?
If the gearbox on your RHINO Lawn Mower is noisy, check the lubricant level as it may be low. If the gears are rough, run them in or change them. If there is a worn bearing, replace it.
General| Brand | RHINO |
|---|---|
| Model | RB60/72 |
| Category | Lawn Mower |
| Language | English |
To Next Page