Ribimex Ribiland 100QJD210-0.75

Questions and Answers

T
Tristan DavisAug 4, 2025
What to do if my Ribimex Ribiland 100QJD210-0.75 has less water outlet?
- E
  Emma ConnerAug 4, 2025
  If your Ribimex Water Pump has less water outlet, here are a few things to check: * Ensure you're using it within the rated head range. * Check for and remove any weeds or foreign matter clogging the strainer and inlet hole. * Inspect the impeller for wear; replace it if it's badly worn. * Make sure the pump is submerged to a depth of at least 0.5m to avoid sucking in air. * Examine the discharge hose for disconnections, leaks, or wear; fix the connection or replace the hose as needed.
F
Frank ClarkeAug 9, 2025
What to do if my Ribimex Ribiland 100QJD210-0.75 stops suddenly?
- S
  Steve CooperAug 9, 2025
  If your Ribimex Water Pump stops suddenly, check the following: 1. Verify that the switch is properly connected and the fuse hasn't burnt out. Ensure the head in use and power voltage comply with requirements, and adjust accordingly. 2. Remove any foreign matter that may be clogging the impeller. 3. If the stator winding is burnt, seek assistance from an authorized service center.
T
Timothy NielsenAug 15, 2025
How to troubleshoot a difficult start for my Ribimex Water Pump?
- R
  Roberta GibsonAug 15, 2025
  If your Ribimex Water Pump is having a difficult start, consider the following: * Ensure the power voltage is within 0.9 to 1.1 times the rated range. * Check the impeller for any clogs and adjust the clogged part. * Verify that you are using the proper cable to avoid a big loss of cable voltage.
A
aguilarrachelAug 21, 2025
How to troubleshoot a Ribimex Ribiland 100QJD210-0.75 that has a difficult start?
- D
  Dr. Courtney Elliott DDSAug 21, 2025
  If your Ribimex Water Pump is having trouble starting, the issue could stem from a few things. First, check that the power voltage is within 0.9 to 1.1 times the rated range. Also, the impeller might be clogged, so inspect and adjust any clogged parts. Lastly, a significant loss of cable voltage can cause starting issues, so ensure you're using the proper cable.
H
Haley SandersAug 27, 2025
What to do if my Ribimex Water Pump experiences a sudden stop?
- J
  Jeffrey BarnesAug 28, 2025
  If your Ribimex Water Pump stops suddenly, start by checking the switch and fuse to ensure they are properly connected and not burnt out. Verify that the head in use and power voltage are compliant with requirements, adjusting as needed. Additionally, the impeller might be clogged; if so, remove any foreign matter. If the stator winding is burnt, seek assistance from an authorised service centre.