TROUBLESHOOTING GUIDE
The following checks will assist in the correction of most problems that you may encounter with your
set. Before going through the checklist below, first check the following points.
**The power cord must be connected firmly.
Should any problem persist after you have made these checks consult your nearest friendly dealer.
Possible Causes (and Remedies)
The function switch is not in the correct
position. Adjust the VOLUME knob.
Rotate the TUNING knob to find a radio station.
Disc play does not start.
Reload the disc with the label side
up. Clean the disc.
Change the installation location.
Programmed disc play will not function
Press the STOP button, and then program the
tracks
Press the PLAY button
Check the light ON/OFF knob
Check the light mode switch (at back cover)
The AC power cord is not connected to an
outlet. Check that the power cord is firmly
connected.
Turn the power button from the “OFF” position to
“ON”
position.
The TV or VTR is too close to the stereo
system. Separate from the TV or VTR.
***THIS OPERATING INSTRUCTION REFLECTS THE CURRENT TECHNICAL SPECIFICATIONS
AT TIME OF
PRINT
. WE RESERVE THE RIGHT TO CHANGE THE SPECIFICATION FOR
TECHNICAL REASON WITHOUT NOTICE.
***PLEASE REFER TO THE RATING LABEL OF THE BACK COVER FOR PRODUCT
SPECIFICATION.
ENGLISH
-
6