Richman RM20-2SS - Regulator and LP Cylinder Connections

Warning
The gas pressure regulator and hose assembly provided with this outdoor cooking appliance must
be used. This regulator is set for an outlet pressure of 11 in. water column (W.C.) / 27.9cm water
column (W.C.).
Regulator:
Your regulator is equipped with a Q.C.C. Type 1 quick connect system. It will not allow gas to flow until a
positive seal has been made. It has a thermal element that will shut off the gas flow if the temperature
reaches 239 degrees F (115 degrees C). It also has a flow-limiting device that will restrict the flow of gas to
9.8 cubic feet per hour (0.28 cubic meters per hour).
To Connect The Cylinder To The Regulator And Hose:
:
1. Be sure the LP cylinder is “OFF” by turning the hand wheel clockwise until it stops.
2. Be sure all burner controls are turned to the “OFF” position.
3. Remove the safety cap from the cylinder valve.
4. Center the nipple of the regulator into the cylinder valve.
5. Turn the black nut clockwise until it stops.
Hand Tighten Only. Do Not Use A Wrench.
CAUTION: When the appliance is not in use the gas must be turned off at the tank.
ITM. / ART. 966690
RM20-2SS Traveler Grill
Regulator and LP Cylinder Connections
14
08/28/13
13