Ricoh 4051 - Erase

Copying
58
2
1.
Top: 0 – 30 mm, 0" – 1.2"
2.
Right: 0 – 30 mm, 0" – 1.2"
3.
Bottom: 0 – 30 mm, 0" – 1.2"
4.
Left: 0 – 30 mm, 0" – 1.2"
A
AA
A
Press [
Edit/Stamp
].
B
BB
B
Press [Edit Image].
C
CC
C
Press [
Scan Position
] .
D
DD
D
Set the scanning position for the
front of the original. Press [↑
↑↑
↑] or
[↓
↓↓
↓ ] to set the top or bottom posi-
tion. Press [←
←←
←] or [→
→→
→] to set the
left or right position.
Note
❒ If you have incorrectly set the
position, readjust with [↑
↑↑
↑], [↓
↓↓
↓ ],
[←
←←
←] or [→
→→
→] .
❒ If you don't need to set the
scanned position of the back of
the original, go to step
F
.
E
EE
E
Set the scanning position for the
back of the original. Press [↑
↑↑
↑ ] or
[↓
↓↓
↓ ] to set the top or bottom posi-
tion. Press [←
←←
←] or [→
→→
→] to set the
left or right position. Then press
[OK].
Note
❒ The scanning position for the
back is valid only when you are
copying 2-sided originals.
F
FF
F
Press [OK].
G
GG
G
Press [OK].
H
HH
H
Place the originals, and then press
the {
{{
{Start}
}}
} key.
Erase
You can erase the center and/or all
four sides of the original image.
This function comes in the following
modes:
❖
❖❖
❖ Border
Erases the original's edge margin
from the copy.
❖
❖❖
❖ Center
Erases the original's center margin
from the copy.
1
2
3
4
MartiniC2_EN_Copy-F1_FM.book Page 58 Tuesday, July 27, 2004 1:43 PM