Connect Copy
84
3
How It Works
Note
❒ In this manual, the two machines connected are referred to as main machine
and sub-machine.
1.
Main machine
2.
Sub-machine
After the original is scanned, the data is stored on the hard disk of the main ma-
chine. As soon as the main machine starts copying, the data is transferred to the
hard disk of the sub-machine, and the sub-machine then starts copying.
The main machine is the one on which you press [Connect]() to make
Connect Copy settings. The other machine becomes the sub-machine.
Machine Types and Options
• Both machines need not be of the same type.
• You can still use Connect Copy without an optional finisher or large capacity
tray (LCT). However, to use the Staple and Punch functions, the optional fin-
isher and punch unit must be installed on both machines. To use the Saddle
Stitch function, the optional booklet finisher must be installed on both ma-
chines. To use the Z-fold function, the optional Z-folding unit and booklet fin-
isher must be installed on both machines.
Interrupt Copy
• You can use the Interrupt function on the sub-machine, but not on the main
machine.
• You cannot use Connect Copy when a job has been paused using the Inter-
rupt function.
MartiniC2_EN_Copy-F1_FM.book Page 84 Tuesday, July 27, 2004 1:43 PM
To Next Page
Loading...
Need help?
General
