Registering Folders
225
7
S Enter the path.
You can enter an absolute path, using this format: “/user/ home/username";
or a relative path, using this format: “directory/sub-directory".
If you leave the path blank, the login directory is assumed to be the current
working directory.
You can also enter an IP address.
You can enter a path using up to 128 characters.
T Press [OK].
U Press [Change] under “Port No.”
V Enter Port No..
To change the port number, press [Change] under Port No.. Enter the port
number using the number keys, and then press the {q} key.
You can enter 1 to 65535.
W Press [Connection Test] to check the path is set correctly.
X Press [Exit].
Y Press [OK].
Z Press [Exit].
Note
❒ To register the name, see Registering Names”.
❒ You can enter up to 64 characters for the user name.
❒ You can enter up to 64 characters for the password.
❒ You can enter a server name using up to 64 characters.
❒ If the connection test fails, check the settings, and then try again.
❒ If User Authentication is specified, contact your administrator.
Reference
p.188 “Registering Names”
p.219 “Locating the SMB folder manually”
p.220 “Locating the SMB folder using Browse Network”
To Next Page
Loading...
