10.3 HDD Unit Replacement
1. Turn off the main switch and unplug the machine.
2. Remove the main controller board bracket. (See Main Controller Board
Bracket Removal.)
3. Remove the wire clamp [A] (1 screw).
4. Remove the HDD unit assembly [B] (3 screws, 2 connectors).
5. Replace the HDD unit [C] (4 screws).
NOTE:
1) Reset the bad sector information (SP4911-6).
2) If the user has registered user stamps in the previous HDD
unit, advise the user that they may need to register them again.
[B]
[C]
[A]
A195R589.wmf
A195
Copier
25 April 1997 INNER AND OUTER COVERS
45
To Next Page
Loading...
