Changing the colour balance
Changes the settings stored in colour balance programs.
1. Press [Edit / Colour].
2. Press [Colour], and then press [Adjust Colour].
3. Press [Colour Balance], and then press [Program Colour Balance].
4. Select the program number (1-3) to be changed.
The programmed colour balance appears.
5. Change the registered settings.
6. Press [Program Colour Balance].
7. Press [Program], and then press the program number to be overwritten.
8. Press [Yes].
The program is overwritten.
9. Press [OK] twice.
Recalling the colour balance
Applies settings registered in colour balance programs to the copy job.
1. Press [Edit / Colour].
2. Press [Colour], and then press [Adjust Colour].
3. Press [Colour Balance], and then press [Program Colour Balance].
4. Select the program number you want to use.
5. Press [OK] twice.
• The adjusted settings will be deleted and the initial values will be reset, when Auto Clear has been
performed, when the [Clear Modes] key has been pressed, or when the power has been turned off.
3. Colour Copying
114
To Next Page
Loading...
Need help?
General
