1. Open the bypass tray.
2. Insert the paper face down until you hear the beep, and then align the paper guides to the
paper size.
If the guides are not flush against the paper, images might be skewed or paper misfeeds might occur.
1. Paper guides
2. Extender
3. Press [Bypass], and then press the [ ] key.
4. Select the size and type of the paper.
5. Press [OK].
6. Place the originals, and then press the [Start] key.
7. When the copy job is finished, press the [Clear Modes] key to clear the settings.
• Certain types of paper might not be detected properly when placed on the bypass tray. If this happens,
remove the paper and place it on the bypass tray again.
• Load only as much paper as can be held between the guides on the bypass tray. Overloading the
bypass tray can result in misfeeds and skewed images.
• To support A4 , 8
1
/
2
× 11 or larger paper sizes, pull out the extender.
• To prevent multiple sheets from being fed at once, fan paper before placing it on the tray.
2. Basic Copying
44
To Next Page
Loading...
Need help?
General
