2
• If the re-entered number does not match, [TEL # does not match] appears on the screen. Go
back to step 3.
7. If you have more originals to scan, press [1] within 60 seconds, place the next original on the
exposure glass, and then press the [OK] key. Repeat this step until all originals are scanned.
If you do not press [1] within 60 seconds, the machine will start to dial the destination.
8. When all originals have been scanned, press [2] to start sending the fax.
Note
• Number confirmation is required only when a fax number is input using the number keys. Number
confirmation is not required when the destination is specified using the Quick Dial, Speed Dial, or
Redial function, or when sending a fax from a computer.
• For more details about other fax functions, see “Using the Fax Function”, User Guide .
Enabling the feature using Web Image Monitor
1. Launch the Web browser.
2. In the Web browser’s address bar, enter “http://(machine’s IP address)/” to access the machine.
3. Click [Machine Settings], and then click the [Fax] tab.
4. From the [Fax Number Confirmation] list, select [ON].
5. Enter the Administrator Password, and then click [OK].
Note
• The [Fax Number Confirmation] setting appears only when [Administrator Password] is specified.
For details about [Administrator Password], see “Configuring the Password”, User Guide
.
To Next Page
Loading...
Need help?
General
