147
MO-C1 Training
Slide 147
General Operation Sequence
6. Paper Exit and Job End
1. After the paper has been cut and the cutter has
returned to its home position, the machine feeds
the paper out of the machine.
2. When the exit sensor detects the trailing edge of
the paper, this signals job end.
3. The paper transport fan switches off and the
paper is reverse fed to the registration standby
position by the registration roller.
4. The machine is ready for the next job.
5. If the machine remains idle for more than 1
minute, the machine goes to Low Power Mode.
If the machine is idle for more than than 14
minutes (default), it will enter the Sleep Mode.
No additional notes
To Next Page
Loading...
