76
MO-C1 Training
Slide 76
Ink Filling - 4
Turn the machine on.
The ink filling sequence will start automatically.
This takes about 20 min. "Initializing Unit" is displayed during
filling, alternately with a near-end message.
If you do not see a message that tells you filling has started, cycle
the machine off/on and try again.
When "Initializing Unit" is not shown any more, this means that the
filling sequence is finished.
After filling, the machine may display the near end alert for one or
more of the color ink cartridges. This is normal. The accessory
cartridges do not contain a large amount of ink. (This pre-near
end alert is not displayed for the black ink cartridge )
Never switch the machine off or try to use the operation panel
during ink filling.
Do not touch the machine during ink filling.
After the procedure is completed, make sure that SP2012-001 has
been set to "0".
The machine should have already done this automatically. If it did
not do this, there is not enough ink in the cartridge, or something
is wrong with the ink supply mechanism.
Discard the filled primer fluid drain cartridges.
No additional notes
To Next Page
Loading...
