77
MO-C1 Training
Slide 77
Alternative Ink Filling Procedure
If one or more of the ID chips on the drain cartridges is
damaged, the draining operation may not start when you
set SP2100-004 to "15".
1. Open SP2012-001 and set it to "3".
2. Turn the machine off.
3. Remove the drain cartridges, and then replace them with
the ink starter cartridges.
4. Close the ink cartridge cover.
5. Turn the machine on.
» Ink filling starts.
» The ink and primer fluid are purged from the tubes, ink sub
tanks and the print heads into the ink collector tank.
6. After the operation is completed, flush all the print heads
three times. ([User Tools> Maintenance> Flush Print
Heads> Select all]).
» At the end of filling and purging of ink and fluid into the ink
collector tank, SP2012-001 resets automatically to "0"
7. Print a Nozzle Check Pattern to check the condition of the
print heads.
No additional notes
To Next Page
Loading...
