80
MO-C1 Training
Slide 80
Setting a Paper Roll - 3
Set the left and right ends of the rolls in the roll feeder sockets, then pull
the leading edge of the paper slightly so that it hangs down.
Always feed the paper from the bottom of the roll, not the top.
» Feeding paper from the top of the roll places an excessive load on the paper
feed rollers, and could cause problems with paper feed and cutting.
» Also, feeding the paper from the top sets the paper against the direction of paper
curl, which causes the paper to rise and rub against the print heads, leading to
poor copy quality and damage to the print heads.
While holding both sides of the leading edge of the paper, rotate and feed
the paper up about 1/3 the distance into the machine.
Make sure that the leading edge of the paper passes over the top
of the
paper guide inside the machine (see the upper left part of the diagram).
No additional notes
To Next Page
Loading...
