82
MO-C1 Training
Slide 82
Setting a Paper Roll - 5
When the message on the operation panel asks ‘Cut’ or ‘No Cut’:
Touch [Cut] to make a clean edge if the paper has been cut
manually or is damp.
Touch [Do Not Cut] if you do not want a fresh cut on the leading
edge of the paper.
It is strongly recommended to select [Cut].
The next message prompts you to confirm the paper type and
thickness.
Touch [Match] if the displayed Paper Type and Paper Thickness
Settings match those of the paper loaded in the machine.
Touch [Does Not Match] if the displayed Paper Type and Paper
Thickness Settings do not match those of the paper loaded in the
machine. Then input the correct settings.
The roll paper feeds into the machine.
Next, the paper will feed out of the machine, reverse feed, and
then automatically stop at the registration standby position.
If [Cut] was selected, then the leading edge of the paper is cut off.
No additional notes
To Next Page
Loading...
