Why does Ricoh Interactive whiteboard say 'The number of handwritten entries exceeds the limit'?
If your Ricoh Interactive whiteboard displays the message that the number of handwritten entries exceeds the limit, resulting in subsequent pages being imported as images, it indicates that you've surpassed the stroke limit. To address this, delete unnecessary pages and strokes.
What to do if Ricoh Interactive whiteboard cannot start remote whiteboard due to a communication error?
If you cannot start the remote whiteboard on your Ricoh Interactive whiteboard and a communication error occurs, it's possible that the destination device is not responding. To resolve this, try starting the remote whiteboard again.
What causes 'A communication timeout has occurred' on Ricoh Interactive whiteboard?
If you encounter the error 'A communication timeout has occurred' on your Ricoh Interactive whiteboard, the possible causes are: * The network cable is not connected or is broken. * The network bandwidth is too low, or the reception is poor (for Remote Viewer only). * The host device is having a problem. To solve this: * Check that the network cable is connected or is not broken. * Check the network band width or the radio reception (for Remote Viewer only). * Access Administrator Settings and check the Network Settings. Be sure to set the IP address.
What to do if Ricoh Interactive whiteboard cannot save the page?
If you are unable to save the page on your Ricoh Interactive whiteboard, it could be due to several reasons: the USB flash memory device was disconnected during saving, the USB flash memory device lacks sufficient free space, or the USB flash memory device is write-protected. To resolve this: * Delete unnecessary data from the USB flash memory device or connect a USB memory device that has sufficient free space. * Configure the USB flash memory device properties to allow information to be written.
How to fix 'Cannot confirm the latest version' on Ricoh Interactive whiteboard?
If your Ricoh Interactive whiteboard cannot confirm the latest version, it may be due to the machine not being connected to the network. Ensure that the network settings are correctly configured and that the network cable is properly connected.
Why does my Ricoh Interactive whiteboard say 'Processing...' or 'Adjusting...' during startup?
If your Ricoh Interactive whiteboard displays a "Processing..." or "Adjusting..." message during startup, it indicates that the sensor adjustment function may have started automatically. Please wait until the message disappears. If a message prompting for user action appears, take the appropriate actions according to the message.
What to do if a communication failure has occurred on Ricoh Interactive whiteboard?
If you encounter a communication failure while using the Ricoh Interactive whiteboard, save the created page. This issue might occur due to a timeout while opening a whiteboard session or an internal error during remote whiteboard usage. To resolve this, quickly press and release the power button of the display. When the machine shuts down, press the power button again to restart the machine.
General| Display Size | 55 inches |
|---|---|
| RAM | 2 GB |
| Internal Storage | 32 GB |
| Brightness | 350 cd/m² |
| Contrast Ratio | 4000:1 |
| Response Time | 8 ms |
| Speakers | 2 x 10 W |
| VESA Mount | 400 x 400 mm |
| Touch Technology | Infrared |
| Connectivity | HDMI, VGA, USB |
| Touch Points | 10 points |
| Processor | Quad-core |
| Resolution | 1920 x 1080 pixels |
To Next Page
