Operation
14
1
Note
❒ Paper with a thickness of 35 - 127.9 g/m
2
can be used. Plain paper of 52.5 -
81.5 g/m
2
is recommended.
❒ About 500 sheets of paper with a 75 g/m
2
thickness is the standard amount
that can be set in the paper feed tray. This amount changes depending on the
paper thickness. In general, set paper at a height less than 55 mm.
❒ Paper with a length of 90 - 275 mm and width of 140 - 395 mm can be set in
the paper feed tray.
❒ The following types of paper are not recommended for this machine:
• Roughly cut paper
• Paper of different thickness and types in the same stack
• Curled or waved paper. Use paper with less than 5 mm curl and 3 mm
wave.
• Grained paper loaded with the direction of the grain perpendicular to the
feed direction
❒ When paper feed problems arise, try using a slower print speed.
To Next Page
Loading...
