2. Jam
Possible Cause:
• An incorrect type or size of document is used.
• The document is too long.
• The scanner rollers (ADF, feed, R1, and scanner rollers) are dirty.
• Obstruction in the document paper path.
• The scan line sensor is defective.
• Defective tx motor
Action:
1. Check that a correct type of document is being used, and that the docu-
ment length is within the maximum setting.
2. Check for obstructions in the paper path.
3. If the problem still remains, do the following.
• Clean the rollers with a soft cloth and water, and replace them if they
are damaged.
• Check that the scan line sensor is working correctly.
• Replace the Tx motor.
August 7th, 1995 TROUBLESHOOTING
MECHANICAL PROBLEMS
6-13
To Next Page
Loading...
