System Switch 04
No FUNCTION COMMENTS
0-2
Not used Do not change the settings.
3
Dedicated transmission
parameter programming
0: Disabled 1: Enabled
This bit must be set to 1 before changing any
dedicated transmission parameters.
4-5
Not used Do not change the settings.
6
CSI programming level
0: User level
1: Service level
1: The CSI can only be programmed using a service
function.
7
Telephone line type
programming mode
0: User level
1: Service level
1: Telephone line type selection can only be
programmed using a service function.
System Switch 05
No FUNCTION COMMENTS
0 Not used Do not change the settings.
1
2
Display of both RTI and CSI
on the LCD
0: Disabled 1: Enabled
1: Both RTI and CSI will be displayed alternately on
the LCD.
3-7
Not used Do not change the settings.
SERVICE TABLES AND PROCEDURES August 7th, 1995
BIT SWITCHES
4-16
To Next Page
Loading...
