Ricoh fax180 - Page 61

G3 Switch 04
FUNCTION COMMENTS
0
to
3
Training error detection
threshold
0 - F (Hex); 0 - 15 bits
If the number of error bits in the received TCF is below
this threshold, the machine informs the sender that the
training has succeeded.
4
to
7
Not used Do not change the settings.
G3 Switch 05
FUNCTION COMMENTS
0
to
3
Initial Tx modem rate
Bit 3 2 1 0 Setting (bps)
0 0 0 1 2.4k
0 0 1 0 4.8k
0 0 1 1 7.2k
0 1 0 0 9.6k
Other settings - Not used
These bits set the initial starting modem rate
for transmission.
4
to
7
Not used Do not change the settings.
G3 Switch 06
FUNCTION COMMENTS
0
to
3
Initial Rx modem rate
Bit 3 2 1 0 Setting (bps)
0 0 0 1 2.4 k
0 0 1 0 4.8 k
0 0 1 1 7.2 k
0 1 0 0 9.6 k
Other settings - Not used
The setting of these bits is used to inform the
transmitting terminal of the available modem
rate for the machine in receive mode.
Use a lower setting if high speeds pose
problems during reception.
4
to
7
Modem types available for reception
Bit 7 6 5 4 Setting
0 0 0 1 V27ter
0 0 1 0 V27ter, V29
Other settings - Not used
The setting of these bits is used to inform the
transmitting terminal of the available modem
type for the machine in receive mode.
SERVICE TABLES AND PROCEDURES August 7th, 1995
BIT SWITCHES
4-30