T
echnical
B
ulletin
PAGE: 4/4
Reissued: 19-Mar-03
Model:
General RTB
Date:
4-Feb-03
No.:
RGene013b
4. Important Notes for Machine Installation – All Products
Please be sure to perform the following at machine installation:
1. If the product is from before the counter modification, i.e. the counter is at a negative
value, be sure to set the counter value to 0 first, then make the installation test
samples.
Digital products Set the electrical counter to 0 with SP mode.
Analog products Set the mechanical counter to 0 with a reset key (tool).
2. If the product is modified, i.e. the counter is already at 0 (or above 0 following pre-
installation at a service depot), simply make the installation test samples.
3. After completing the installation, make sure to record the counter value. This is very
important, as this value will be used for billing with Meter Click contracts. Also, inform
the customer of the value along with the reason why the counter does not start from
“0”.
To Next Page
Loading...
