6
Attaching the Spacer to the Fusing Rail
1. Remove the fusing unit.
2. Clean the attachment area for the rail spacer with alcohol.
3. Attach the rail spacer (B0514370) to the rear of the non-sliding fusing rail [A] so that the
tapered side [B] is facing the front.
Note:
1. The actual color of the B0514370 service part rail spacer is black.
2. After attaching the spacer, move the fusing unit along the rail to make sure the spacer
does not interfere with the rail.
A
B
Sliding rail cutout
Rear side
plate
B
Sliding Rail
To Next Page
Loading...
