3. Now click Tools > Colour Management, you will see the Colour Management Dialogue Box appear as shown below.
Firstly, make sure that the arrows are highlighted as above. To select or deselect an arrow, click directly on the arrow itself.
Also select RGB under the ‘Color mode used for effects:’ option.
Make sure that the drop down option below the centre circle shows ‘Internal RGB - Fraser (1998)’, and the drop down
option below the printer to the left hand side states ‘Ricoh - 7000 v1.15'.
11
CorelDRAW 10 - X4 Setup
To Next Page
Loading...
