Why are images cut off when printing from my Ricoh Printer?
If the images are cut off or excess is printed by your Ricoh Printer, it might be because you are using paper smaller than the size selected in the application. Use the same size paper as selected in the application. If you cannot load paper of the correct size, use the reduction function to reduce the image, and then print.
What to do if the Ricoh SP C435DN toner has run out?
If your Ricoh Printer indicates that the toner has run out, you should replace the print cartridge.
What to do if Ricoh SP C435DN waste toner bottle is full?
If your Ricoh Printer displays a message indicating that the waste toner bottle is full, you should replace the waste toner bottle.
What to do if Ricoh SP C435DN Printer cartridge is almost empty?
If your Ricoh Printer displays a message that the print cartridge is almost empty, replace the print cartridge.
Why is the printed image smudged on my Ricoh SP C435DN?
If the printed image from your Ricoh Printer is smudged, especially when using thick paper in the bypass tray, it might be because the settings for thick paper haven't been configured correctly. For PCL 5c: On the printer driver's [Paper] tab, select [Bypass Tray] in the "Input Tray:" list, then select the appropriate paper type in the "Type:" list. For PCL 6/PostScript 3: On the printer driver's [Detailed Settings] tab, click [Paper] in "Menu:", then select [Bypass Tray] in the "Input Tray:" list, and choose the correct paper type in the "Paper Type:" list.
How to fix Ricoh SP C435DN Printer not automatically recognized?
If the Ricoh Printer is not automatically recognized, it might be due to an improperly connected USB cable. Try disconnecting the USB cable, turning the printer off and then on again. After the printer fully boots up, reconnect the USB cable.
What to do if Ricoh SP C435DN cannot detect the wireless LAN interface board?
If your Ricoh Printer cannot detect the wireless LAN interface board, check that the board is supported or installed correctly.
Why does my Ricoh SP C435DN take so long to resume printing?
If your Ricoh Printer takes too long to resume printing, it is because the printer was in Energy Saver mode or Sleep mode. The printer must warm up, and this takes time until printing starts.
Why does my Ricoh SP C435DN take so long to print?
If it takes a long time to complete the print job on your Ricoh Printer, it may be because photographs and other data-intensive pages take a long time for the printer to process. Simply wait when printing such data.
Why is my Ricoh Printer printing faded images?
If the printed image from your Ricoh Printer is faded across the entire page, it could be because the paper is unsuitable. Printing on coarse or treated paper might result in a faint print image. Use recommended paper.
General| Print Technology | Laser |
|---|---|
| Color Output | Color |
| Print Resolution | 1200 x 1200 dpi |
| Operating System Compatibility | Windows, Mac OS, Linux |
| AirPrint Enabled | Yes |
| Automatic Duplexing | Yes |
| Connectivity | Ethernet, USB |
| Interface | USB, Ethernet |
| Media Type | Plain Paper, Recycled Paper, Label Paper, Envelope, Transparency |
| Media Sizes | A4, A5, A6, B5, B6, Letter, Legal, Executive, Folio |
| Envelope Sizes | C5, C6, DL, Monarch |
To Next Page
