Ride JAVA - Tools and Hardware; Mounting Hardware

the need for anti-tippers or amputee axle adapter brackets to be added to your
wheelchair to help increase stability. Similarly, a more forward back position
might reduce the forward stability of the wheelchair, increasing risk of tipping
forward, with potential for injury.
WARNING: Do not use your JAVA Back without the foam insert and cover in
place.
WARNING: Failure to properly place and secure the JAVA Back to your
wheelchair might result in serious injury.
WARNING: Failure to accurately assess and adjust the fit of the JAVA Back might
result in serious injury.
CAUTION: Do not lift the wheelchair by the JAVA Back.
I. Tools and Hardware
The JAVA Back comes fully assembled and ready to install. The tools you need to
install and adjust the JAVA Back are included in the package:
 •one4mmAllenwrench
 •one5mmAllenwrench
 •twoclampscrewsformountingbackto¾"diameterbackcanes.
II. The Mounting Hardware
Themountinghardwaretsallcommonwheelchairframetubingfrom¾"to1"
diameter. Use the screws that are already in the clamps for 7/8 inch and 1 inch
diameter tubing. Use the shorter screws, included in the Java Back Tools kit, for
¾"tubing.
2
Figure 1