To Next PageTo Next Page
Need help?Do you have a question about the RIDGID R350RHA and is the answer not in the manual?
Wear eye protection, stay alert, dress properly, and avoid fatigue or impairment.
Do not use oxygen or combustible gases; ensure air pressure does not exceed 200 P.S.I.
Do not load with controls activated; keep body parts clear of discharge area.
Lubricate the tool and check air compressor gauge for proper operating pressure.
Connect tool to clean, dry compressed air at regulated pressures between 70-120 psi.
Connect to air supply before loading; feed nails correctly and slide pusher.
Provides the most accurate fastener placement.
Allows very fast repetitive fastener placement.
Set air pressure based on nail size and workpiece material for best results.
Adjust the driving depth of the nail on a scrap workpiece for desired depth.
Procedure to clear a jammed nail using a screwdriver and hammer.
Read and understand the manual to avoid serious personal injury.
Wear safety goggles to prevent severe eye damage from flying objects.
Warnings about using correct parts, PPE, and disconnecting air supply before maintenance.
General
