Why does wood burns at tailstock end of my RIDGID Lathe?
If the wood burns at the tailstock end of your RIDGID Lathe, the cup center may be too tight or not lubricated. Back off the tailstock ram and lubricate the cup center. Consult the Basic Lathe Operation Section, specifically “Spindle Turning,” for more details.
How to fix tailstock rocks back and forth excessively on RIDGID WL1200?
If the tailstock on your RIDGID Lathe rocks back and forth excessively, the brass adjusting screw may be too loose. Adjust the screw. Refer to the “Getting To Know Your Lathe” Section for detailed instructions.
Covers signal words, pre-operation checks, and installation safety for the lathe.
Details recommended accessories, injury prevention, and workpiece inspection for safe operation.
Explains chisel types, selection, theory of turning, and cutting vs. scraping.
Covers tool rest positioning, and techniques for using gouges and skews.
Details on roughing, sizing, smoothing, shoulders, vees, beads, and coves.
Covers duplicate turnings, spindles, drilling, faceplate work, cylinders, and balls.
Addresses common problems like motor not running or lathe slowing down.
Diagnoses motor issues such as noise, low power, overheating, or starting problems.
To Next Page
General
