20023724
6
GB
3.2 BOILER FIXING
To fit the burner to the boiler it is necessary to carry out the following:
Widen, if necessary, the insulating gasket holes (3, fig. 3).
Fix the flange (5) to the boiler door (1) using four screws (4) and (if necessary) the nuts (2) interposing
the insulating gasket (3) but keep unloosing one of the two upper screws (4) (see fig. 2).
Put on the flange (5) the burner combustion head, tighten the flange with the screws (6) and lock the
loose screw (4).
N.B.: The burner can be fixed with the variable dimension (A) (see fig. 4). Anyway, make sure that the
combustion head crosses completely the boiler door thickness.
3.3 PROBE-ELECTRODE POSITIONING
Fig. 2
Fig. 3
Fig. 4
TYPE A
915 T1 116 - 70
916 T1 114 - 100
917 T1 128 - 110
918 T1 167.5 - 145
A
D5012
D5011
S7002
D6088
± 0.3
3.5 ± 0.3
A
Fig. 5
1
3
2
4
ATTENTION
Ensure that the plate (3, fig. 5) is always inserted
in the flattening of the electrode.
Lean the probe insulator (4) against the cup (2).
TYPE
915T1
916T1 917T1 918T1
A
17 30 31 31
To Next Page
Loading...
