Riello RTC Series - Page 35

35
INSTALLATION
Door - RTC 8000 - RTC 10000
Open the door, unscrew the nuts (1) securing the cover bracket (2)
and remove the bracket.
1
2
Hermetically close the door again by tightening the bolts (3) until
the door compresses the braided seal.
3
Top hinge
Loosen the nut (4) and remove the circlip (5).
Remove the through bolt (6).
4
6
5
Remove the four nuts (7) and remove the bracket (8).
8
7
Fit the hinge on the opposite side, reversing the steps described
above.
Bottom hinge
Loosen the nut (4).
Loosen the nut (5), unscrew and remove the through bolt (6).
5
4
6
Remove the four nuts (7) and remove the bracket (8).
8
7
Fit the hinge on the opposite side, reversing the steps described
above.