Riello RTC Series - Door Hinges; Changing the Direction of Door Opening

34
INSTALLATION
2.11 Door hinges
Two different door hinge systems have been used to meet differ-
ent design requirements
− RTC 3000 - RTC 6000: there are four hinges, two for the up-
per door of the burner and two for the door of the reverse
ow combustion chamber.
− RTC 8000 - RTC 10000: The front door opens on two hinges.
RTC 3000-RTC 4000-RTC 5000-RTC 6000
RTC 8000-RTC 10000
2.11.1 Changing the direction of door opening
The boiler door hinges are tted on the right of the door in the
factory. If you need to reverse the direction of opening, remove
the boiler’s side panel and proceed as follows.
Door - RTC 3000 - RTC 6000
Check that the main door xing bolts (1) are tight and then remove
the safety bolts (2).
2
1
Remove the nuts and door brackets (3).
3
Insert a spanner through the top side slot and hold the bushing
(4) steady.
Unscrew the top screw (5), then remove the bushing (4) and
washer (6).
4
6
5
Remove the three bolts (7) and remove the bracket (8).
7
8
7
Fit the hinge on the opposite side, reversing the steps described
above.
Repeat these steps for the other hinges.