INSTALLATION
INSTALL THE BATTERIES
1) Rotate the right ear pad until it detaches from the headphones.
2) Insert the two included batteries, ensuring proper polarity.
3) Align the ear pad and rotate it back into place.
4) Please use only included proprietary batteries. They are made to not have to be
replaced, but if yours appear to be dying, please contact customer support.
Important: Please charge your headphones for at least 6 hours before first use.
Do so by turning the headphones OFF, pressing the power button and holding
for a couple seconds. Place the set on the transmitter. The charging process will
begin immediately, signified by the LED light glowing green. When the charge is
complete, the light will shut o.
To Next Page
Loading...