Riigaku
Incident optics unit # 1
CBO unit
Just by changing the selection slits, the beams can be switched between
divergent beam and the beams formed by using a multilayer mirror
(parallel/convergent/monochromatized divergent). Parallel beam can also be
formed into a narrow beam for small-angle scattering measurements
or
a point
beam for micro area measurements by using the appropriate selection slits.
Fine adjustments
of
the multilayer mirror can be performed via SmartLab Studio
II.
Table
CBO
unit
Unit name
CBO (for Cu only)
(optional: C484-0001-3-31)
Applicable only to Cu wavelength,
and enables the switching between
divergent and parallel beams.
CBO-E (for Cu only)
(optional: C484-0001-3-38)
Applicable only to Cu wavelength,
and enables
th
e switching between
divergent and convergent beams.
CBO-a
(for Cu only)
( optional: A00004622)
Abbreviation
CBO
(Cu)
CBO-E
Applicable only to Cu wavelength, CBO
-a
and enables the switching between
divergent and monochromatized
divergent beams.
CBO-Cu/Co (for Cu and Co)
(optional: C267-0017)
Applicable to Cu and Co CBO
(Cu
/
Co)
wavelengths, and enables the
switching between divergent and
parallel beams.
CBO-
Mo
(for Mo only)
(optional:
AOOOOl
71
6)
Applicable o
nl
y to
Mo
wavelength,
and enables the switching between
divergent and parallel beams.
CBO-Mo
Illustration
SmartLab SE: Automated Multipurpose X-ray Diffractomet
er
23
To Next Page
Loading...
