Contact us at support@RIGDOO.tech
and view HT-10.
On
→ You'll be prompted to enter a 1-9&A-Z numeric code.
And you will need to enter this password every time
you turn on HT-10.
Note: It is recommended that you write your password on a sticky
note when you set it.
If you forgot the password
. Turn off HT-10 at
first. Press replay button and up button at the same time (Don't let
go of your fingers) , then turn power switch from OFF to TEST.
HT-10 will remove the password for you automatically.
17) [Beep Sound]: Turn the button beep sound on / off .
On (Default) → To turn on the beep sound. (Press any
button will beep)
Off → To turn off the beep sound.
18) [Format Memory Card]: Decide carefully! If you format the
memory card, you will lose all the data on the card.
Note: If there are photos or videos on the card that you
want to keep, you should use the USB cable or SD
card reader to read the data and back it up to your
computer or other device before formatting.
No (Default) → Won't do any things.
Yes → Format the SD card and delete all files.
19) [Serial NO]: Give the current camera a 0-9&A-Z code name.
This 0-9&A-Z number will be displayed on the left side of
Photo Stamp. It usually used to distinguish which camera
the photo was taken from. (If you have more than one HT-10
camera)
To Next Page
Loading...