Contact us at support@RIGDOO.tech
Off (Default)
→ No Serial No.
On
→ You'll be prompted to enter a 0-9&A-Z Serial
No.
20) [Reset Settings]: Reset HT-10 to its Factory Settings.
No (Default) → Won't do any things.
Yes → Reset to factory settings.
21) [Version]: Current firmware version
This firmware can be updated via the most recent firmware
downloaded by contacting customer service.
OTHER FUNCTIONS
1) [USB Boot]: When you find that the HT-10 does not
turn on properly.
i. Connect the USB Cable to the computer (do not connect
the camera yet)
ii. Press and hold the "UP" button.
iii. Plug in the USB Cable.
iv. LCD screen will light up and automatically enter the system.
v. When you find that the camera has successfully entered
the system, you can release your fingers at this point.
vi. At this point, please put in 8 fresh batteries.
vii. Finally, unplug the USB Cable.
2) [Playback]: View photos or videos directly on the LCD
screen.
Switch the power switch from OFF to TEST.
To Next Page
Loading...