Rigol DG811 - General Inspection

RIGOL Chapter 2 Command System
2-2 DG800 Programming Guide
:COUNter Commands
The :COUNter commands are used to enable or disable the frequency counter; set the related information
of the frequency counter.
Command List
[1]
:
 :COUNter:AUTO
 :COUNter:COUPling
 :COUNter:GATEtime
 :COUNter:HF
 :COUNter:LEVEl
 :COUNter:MEASure?
 :COUNter:SENSitive
 :COUNter[:STATe]
 :COUNter:STATIstics:CLEAr
 :COUNter:STATIstics[:STATe]
Note
[1]
: In the "Command List" in this manual, the parameters in the setting commands and the query
commands are not included and you can refer to the complete introductions of the commands in the text
according to the keywords.