Need help?Do you have a question about the Rigol DG811 and is the answer not in the manual?
General| Brand | Rigol |
|---|---|
| Model | DG811 |
| Category | Laboratory Equipment |
| Language | English |
Overview of essential safety precautions for instrument operation.
Instructions for inspecting the packaging and instrument upon receipt.
Detailed explanation of the controls and indicators on the front panel.
Description of the connectors and ports available on the rear panel.
Steps required to connect the instrument to power and initial setup.
Explanation of the graphical display elements and navigation.
Procedures for generating standard waveforms like Sine, Square, and Ramp.
Steps to select and configure either Channel 1 or Channel 2 for output.
Guide on choosing from the available basic waveform types.
How to set the frequency or period for output waveforms.
Instructions for configuring the output amplitude and high-level settings.
How to set the DC offset and low-level voltage for the output signal.
Steps to activate the signal output from a selected channel.
Procedures for using built-in arbitrary waveforms.
How to activate the arbitrary waveform generation function.
Guide on selecting from the library of built-in arbitrary waveforms.
How to adjust frequency, amplitude, offset, and phase for arbitrary waveforms.
Instructions for generating harmonic signals.
How to configure and output DC signals.
Introduction to advanced waveform generation modes.
Overview of waveform modulation capabilities.
How to perform Amplitude Modulation.
Covers selecting AM, carrier waveform, and setting parameters.
How to perform Frequency Modulation.
Covers selecting FM, carrier waveform, and setting parameters.
How to perform Phase Modulation.
Covers selecting PM, carrier waveform, and setting parameters.
Procedures for generating sweep waveforms.
Procedures for generating burst waveforms.
Introduction to the instrument's frequency counter capabilities.
Instructions for configuring gate time, measurement parameters, and statistics.
Configuring output parameters for individual channels.
Setting up frequency, amplitude, and phase coupling between channels.
Adjusting language, power-on state, clock source, and beeper.
Configuring IP address, subnet mask, and gateway for network connection.
Restoring factory default settings or saving/recalling user-defined states.
Steps for controlling the instrument remotely using a USB connection.
Procedures for remote control using a LAN (Ethernet) connection.
Guide for remote control using a GPIB interface.
Solutions for instrument not powering on or screen display problems.
Troubleshooting generator lock and no waveform output problems.
To Next Page
