Need help?Do you have a question about the Rigol DG812 and is the answer not in the manual?
General| Output Channels | 2 |
|---|---|
| Sampling Rate | 125 MSa/s |
| Resolution | 14 bits |
| Output Impedance | 50 Ω |
| Harmonic Generator | Yes |
| Sweep Modes | Linear, Logarithmic |
| Waveform Types | Sine, Square, Ramp, Pulse, Noise |
| Modulation | AM, FM, PM, PWM |
| Interfaces | USB, LAN |
| Frequency Range | 1 μHz to 12 MHz |
Basic safety precautions to avoid injury or damage.
Explains warnings, cautions, and safety symbols used.
Procedures for inspecting packaging, instrument, and accessories.
Displays physical dimensions and views of the DG800 unit.
Details all keys, connectors, and controls on the front panel.
Identifies and describes connectors and ports on the rear panel.
Instructions on connecting to AC power and initial setup.
Explains the layout and components of the DG800 display interface.
Guide on accessing and using the instrument's help features.
How to generate and configure standard waveforms like Sine, Square, etc.
Instructions for generating and using built-in arbitrary waveforms.
How to configure the generator to output harmonic signals.
Method for outputting a DC signal with adjustable offset.
Steps to generate a dual-tone signal.
Details on generating PRBS, RS232, and Sequence waveforms.
Overview of modulation types and their configuration.
How to generate frequency sweep waveforms (Linear, Log, Step).
Configuration for burst waveform generation (N Cycle, Infinite, Gated).
How to use the instrument's built-in frequency counter.
Managing instrument states and waveforms via internal/external memory.
Configuring output parameters for CH1 and CH2.
How to enable and configure sync signals for channels.
Setting up frequency, amplitude, and phase coupling between channels.
Enabling or disabling track function for channel parameter synchronization.
Combining basic waveforms with other signals.
Accessing and configuring system-wide parameters.
Restoring factory presets and saving user-defined states.
Procedures for installing optional features using license files.
Methods for locking front panel keys and the touch screen.
Controlling the DG800 using a USB connection to a PC.
Remote control via Ethernet/LAN connection using network cable.
Controlling the DG800 via GPIB interface using USB-GPIB converter.
Solutions for common problems like no display, dark screen, locked generator, no waveform.
Lists standard accessories, options, and their order numbers.
Details the product warranty terms and conditions.
To Next Page
