Rigol DG812 - To Output Dual-tone Waveform

Chapter 2 Front Panel Operations RIGOL
DG800 User's Guide 2-29
To Output Dual-tone Waveform
Press Menu  Continuous  "Dualtone" to enter the dual-tone signal parameter
setting interface.
1. Freq1/CentFreq: sets the output frequency/period of Signal 1 in the dual-tone
signal.
2. Freq2/OffsFreq: sets the output frequency/period of Signal 2 in the dual-tone
signal.
3. Ampl/HighL: sets the output amplitude/high level of the dual-tone signal.
4. Offset/LowL: sets the output offset/low level of the dual-tone signal.
Please refer to "To Output Basic Waveform" to configure the parameters and
output for the channel.