Rigol DG811 - To Output Harmonic

Chapter 2 Command System RIGOL
DG800 Programming Guide 2-39
:MMEMory:LOAD:STATe
Syntax
:MMEMory:LOAD:STATe <file_name>
Description
Loads the specified state file from the current directory.
Parameter
Name
Type
Range
Default
<file_name> ASCII String
The filename of the state file in
the current directory
None
Remarks
The parameter <file_name> is the filename of the state file in the current directory and it is a string
enclosed by double quotation marks. For example, "Rigol0.RSF".
Example
Assume that the current directory is D:\.
:MMEM:LOAD:STAT "D:\Rigol0.RSF" /*Loads the state file Rigol0.RSF from the external memory (D:\).*/
:MMEMory:MDIRectory
Syntax
:MMEMory:MDIRectory <dir_name>
Description
Creates a folder in the current directory with a specified name.
Parameter
Name
Type
Range
Default
<dir_name>
ASCII String
Refer to "Remarks".
None
Remarks
 The parameter <dir_name> is a string enclosed by double quotation marks. The content in the double
quotation marks is the name of the folder to be created and its length cannot exceed 7 characters. The
name can be composed of Chinese characters, English uppercase characters and numbers. Wherein,
one Chinese character is counted as 2 characters.
 If a folder with the same name is found in the current directory, the system displays a prompt message,
indicating that errors occur on the remote command.
 This command is only applicable to the external memory.
Example
Assume that the current directory is D:\.
:MMEM:MDIR "RIGOL1" /*Creates a folder named "RIGOL1" under the directory of Disk D.*/